MultiEmStat4
Multi-channel Potentiostat / Galvanostat / Impedance Analyzer
- Available with 4, 8 or 12 channels
- FRA / EIS: 10 μHz up to 200 kHz
- Potential range: ±3 V (LR) or ±6 V (HR)
- Max. current: ±30 mA (LR) or ±200 mA (HR)
No Compromises on Productivity and Performance
The MultiEmStat4 is a compact Potentiostat, Galvanostat, and optional Frequency Response Analyser (FRA) for Electrochemical Impedance Spectroscopy (EIS) with 4, 8 or 12 channels. The MultiEmStat4 comes in two versions; the Low Range version is great for applications that require a low current range down to 1 nA, whereas the High Range version is very suitable for applications that need a maximum current of 200 mA.
The MultiEmStat4 is controlled with MultiTrace for Windows, or you can write your own MethodSCRIPT and control it from any platform or operating system.
Synchronizing channels in Synched mode
By enabling synchronization of channels and adjusting the setup of your cables, you can use the MultiEmStat4 as a polypotentiostat. This means you can use multiple working electrodes, one counter and one reference electrode in the same cell at the same time. Your working electrodes all perform the same measurement.
Voltammetric techniques
- Linear Sweep Voltammetry (LSV)
- Cyclic Voltammetry (CV)
Amperometric techniques
- Chronoamperometry (CA)
- Zero Resistance Amperometry (ZRA)
- Chronocoulometry (CC)
- MultiStep Amperometry (MA)
- Pulsed Amperometric Detection (PAD)
Galvanostatic techniques
- Linear Sweep Potentiometry (LSP)
- Chronopotentiometry (CP)
- MultiStep Potentiometry (MP)
- Open Circuit Potentiometry (OCP)
Pulsed techniques
- Differential Pulse Voltammetry (DPV)
- Square Wave Voltammetry (SWV)
- Normal Pulse Voltammetry (NPV)
Other
- Mixed Mode (MM)
- Potentiostatic/Galvanostatic Impedance spectroscopy (EIS / GEIS)
- Potential scan or current scan
- Fixed potential or fixed current
- Time scan
MultiTrace for Windows
The MultiTrace software gives you full control over the channels of our multi-channel instruments. MultiTrace can be used with multi-channel potentiostats in two different modes; the Individual and Simultaneous mode.
Individual mode
All potentiostats are used independently. Measurements can be started on all channels with one click, or one at a time on individual channels. Each measured curve is shown in its own plot.
Simultaneous mode
All channels run the same measurement at the same time (optionally hardware-synchronized). The measured curves are displayed in a single plot and can be stored together in a single data file or in separate data files.
