MultiPalmSens4
Multi-channel Potentiostat / Galvanostat / Impedance Analyzer
- 4 to 10 channels available in different configurations
- FRA / EIS: 10 μHz up to 1 MHz
- 9 current ranges: 100 pA to 10 mA
- potential range: ±5 V or ±10 V
The MultiPalmSens4 is a flexible multi-channel potentiostat, galvanostat and impedance analyzer which you can fully tailor to your requirements and budget. The MultiTrace software allows for using each channel individually or simultaneously or running a sequence of automated tasks on each channel. Each channel provides an additional auxiliary port for controlling peripherals or monitoring temperature or other analog signals.
Configure your ideal multi-channel potentiostat
Each channel can be configured with:
- ±5 V or ±10 V maximum potential range
- EIS/FRA with maximum frequency of 100 kHz or 1 MHz
- Bipotentiostat module for second WE
- iR-Compensation
- Galvanic isolation
Synchronizing channels in Synched mode
By enabling synchronization of channels and adjusting the setup of your cables, you can use the MultiPalmSens4 as a polypotentiostat. This means you can use multiple working electrodes, one counter and one reference electrode in the same cell at the same time. Your working electrodes all perform the same measurement.
Voltammetric techniques
- Linear Sweep Voltammetry (LSV)
- Cyclic Voltammetry (CV)
- Fast Cyclic Voltammetry (FCV)
- AC Voltammetry (ACV)
Pulsed techniques
- Differential Pulse Voltammetry (DPV)
- Square Wave Voltammetry (SWV)
- Normal Pulse Voltammetry (NPV)
Amperometric techniques
- Chronoamperometry (CA)
- Zero Resistance Amperometry (ZRA)
- Chronocoulometry (CC)
- MultiStep Amperometry (MA)
- Fast Amperometry (FAM)
- Pulsed Amperometric Detection (PAD)
- Multiple-Pulse Amperometric Detection (MPAD)
Galvanostatic techniques
- Linear Sweep Potentiometry (LSP)
- Chronopotentiometry (CP)
- MultiStep Potentiometry (MP)
- Open Circuit Potentiometry (OCP)
- Stripping Chronopotentiometry (SCP or PSA)
Other
- Mixed Mode (MM)
Potentiostatic/Galvanostatic Impedance spectroscopy (EIS/GEIS)
- Potential scan or current scan
- Fixed potential or fixed current
- Time scan
MultiTrace for Windows
The MultiTrace software gives you full control over the channels of our multi-channel instruments. MultiTrace can be used with multi-channel potentiostats in two different modes; the Individual and Simultaneous mode.
Individual mode
All potentiostats are used independently. Measurements can be started on all channels with one click, or one at a time on individual channels. Each measured curve is shown in its own plot.
Simultaneous mode
All channels run the same measurement at the same time (optionally hardware-synchronized). The measured curves are displayed in a single plot and can be stored together in a single data file or in separate data files.
